View Full Version : DIY Ouya Clear NES Case Mod.
07-04-2013, 06:21 AM
work in progress along with my USB port DIY.
its NOT perfect, I am not a pro DIY for a reason.
- 1 Acrylic Plastic 0.2 cm Thick, 20cm x 25cm Length
- 1 Acrylic Plastic Cutting Knife
- Glue Gun
The sizes I used to cut are as follows:
You will need 2 of each of these.
EDIT: the 2.5cm x 12.6cm MUST be cut to 2.5cm x 8.2cm
07-04-2013, 06:22 AM
using some sort of sticky Eraser i found in my house to hold the Ouya in place
final product for now. a few little things to finish, may add some LED's later.
07-04-2013, 07:37 AM
Looks interesting. Can't wait to see the final product.
07-04-2013, 04:15 PM
That is awesome, i wanna see the finished product. Run some leds inside the case while you're at it.
Sent from my Xoom using Tapatalk 2
07-05-2013, 01:38 PM
It is starting to become quite neat that case. Where did you get that USB Hub and how did you integrated it on ouya?
07-05-2013, 02:07 PM
Its a little ruff around the edges but it's still cool, nice job!
07-17-2013, 02:00 PM
I think a down scale version on the nes would look better but still awesome
07-18-2013, 07:10 AM
Excellent job! Although, I do worry about hot air getting trapped under the PCB with the fan on top like that.
07-18-2013, 04:53 PM
i like it if u decide to paint it you can use a little filler to fix the gaps but i think its pretty damn sweet myself
Powered by vBulletin® Version 4.2.1 Copyright © 2019 vBulletin Solutions, Inc. All rights reserved.