WIP: mini NES case

[skylargray]

how do u plan to add extra usb ports?

With one of these:
http://www.amazon.com/gp/product/B005HKIDF2/

You pull this hub out of its case, and I have made accommodations on the front of my mininess case specifically for it.
I have already confirmed that this hub works with the OUYA and my USB thumb drive/card reader.

[jimlab7]

With one of these:
http://www.amazon.com/gp/product/B005HKIDF2/

You pull this hub out of its case, and I have made accommodations on the front of my mininess case specifically for it.
I have already confirmed that this hub works with the OUYA and my USB thumb drive/card reader.

so do u think a 4way hub would be to much for the ouya?

[skylargray]

so do u think a 4way hub would be to much for the ouya?

If it's a self-powered hub, it should work fine.
If it relies on the host for power, then you only get 125mA per port. This will cause many devices to not enumerate. It's my understanding that the OUYA is already pretty picky about USB device enumeration as it is, so a 4-port hub just sounds like asking for trouble.

[jimlab7]

If it's a self-powered hub, it should work fine.
If it relies on the host for power, then you only get 125mA per port. This will cause many devices to not enumerate. It's my understanding that the OUYA is already pretty picky about USB device enumeration as it is, so a 4-port hub just sounds like asking for trouble.

so im finding out xD

---

so have u found a red led your using for this project and if so what one since im going to buy one i would like to not buy too many wrong ones like i did with my usb hubs xD